Power Management ICs

Battery Protection IC For 2-serial / 3-Serial Cell Pack (Secondary Protection) S-8223A/B/C/D Series

The S-8223A/B/C/D Series is used for secondary protection of lithium-ion rechargeable batteries, and incorporates high-accuracy voltage detection circuits and delay circuits.
Short-circuits between cells accommodate series connection of two cells or three cells.
The S-8223B/D Series limits its CO pin output voltage to 11.5 V max., so a FET with the gate withstand voltage of 12 V can be used.


High-accuracy voltage detection circuit for each cell
Overcharge detection voltage n (n = 1 to 3)
  3.600 V to 4.700 V (50 mV step)
    : Accuracy ±20 mV (Ta = +25°C)
    : Accuracy ±25 mV (Ta = −10°C to +60°C)
Overcharge hysteresis voltage n (n = 1 to 3)*1
 0.0 mV to −550 mV (50 mV step)
 −300 mV to −550 mV : Accuracy ±20%
 −100 mV to −250 mV : Accuracy ±50 mV
 −50 mV : Accuracy ±25 mV
 0.0 mV : Accuracy −25 mV to +20 mV
Delay times for overcharge detection are generated only by an internal circuit (external capacitors are unnecessary)
Overcharge detection delay time is selectable : 1 s, 2 s, 4 s, 6 s, 8 s
Overcharge release delay time is selectable : 2 ms, 64 ms
Built-in timer reset delay circuit
Output form is selectable (S-8223A/C Series)
CMOS output, Nch open-drain output
Output logic is selectable (S-8223A/C Series)
Active "H", active "L"
CO pin output voltage is limited to 11.5 V max. (S-8223B/D Series)*2
High-withstand voltage
Absolute maximum rating 28 V
Wide operation voltage range
3.6 V to 28 V
Wide operation temperature range
Ta = −40°C to +85°C
Low current consumption
During operation (VCU − 1.0 V for each cell)
 : 0.25 μA typ., 0.5 μA max. (Ta = +25°C)
During overdischarge (VCU × 0.5 V for each cell)
 : 0.3 μA max. (Ta = +25°C)
Lead-free (Sn 100%), halogen-free

*1. Select the overcharge hysteresis voltage calculated as the following formula. (Overcharge detection voltage n) + (Overcharge hysteresis voltage n) ≥ 3.4 V

*2. Only output logic active "H" is available.


  • Lithium-ion rechargeable battery packs (for secondary protection)

Parts List

  • U(Ux), S and G at the end of the product name of ABLIC Inc. were used to indicate different material specifications as “environmental code”,
    however, these have now been unified into “lead-free and halogen-free” and are identical in terms of environmental quality.
  • Note: Lead-free plating other than 100% Sn is applied to some limited old products, therefore, please contact our sales representatives for details.
  • These descriptions may be different from the actual product name and parameter.
    Please confirm the product name and specifications with the data sheet again.
  • The information herein is subject to change without notice.